This paper presents an algorithm for extending B-spline curves and surfaces. Based on the unclamping algorithm for B-spline curves, we propose a new algorithm for extending B-spline curves that extrapolates using the recurrence property of the de Boor algorithm. This algorithm provides a nice extension, with maximum continuity, to the original curve segment. Moreover, it can be applied to the extension of B-spline surfaces. Extension to both single and multiple target points/curves are considered in this paper.

This paper addresses the problem of approximate merging of two adjacent B-spline curves into one B-spline curve. The basic idea of the approach is to find the conditions for precise merging of two B-spline curves, and perturb the control points of the curves by constrained optimization subject to satisfying these conditions. To obtain a merged curve without superfluous knots, we present a new knot adjustment algorithm for adjusting the end k knots of a kth order B-spline curve without changing its shape. The more general problem of merging curves to pass through some target points is also discussed.

Mesh parameterization is a key problem in digital geometry rocessing. By cutting a surface along a set of edges (a seam), one can map an arbitrary topology surface mesh to a single chart. Unfortunately, high distortion occurs when protrusions of the surface (such as fingers of a hand and horses’ legs) are flattened into a plane. This paper presents a novel skeleton-based algorithm for computing a seam on a triangulated surface. The seam produced is a full component Steiner tree in a graph constructed from the original mesh. By generating the seam so that all extremal vertices are leaves of the seam, we can obtain good parametrization with low distortion.

We investigate the propagation of errors through geometric transformations, such as re°ections, rotations, similarity transformations, and projections, and also the scalar product of vectors. This means computing tolerance zones of points which undergo such transformations, if these points and the transformations themselves are given by toleranced input data.

We give a new, simple algorithm for simultaneous degree elevation and knot insertion for B-spline curves. The method is based on the simple approach of computing derivatives using the control points, resampling the knot vector, and then computing the new control points from the derivatives. We compare our approach with previous algorithms and illustrate it with examples.